1. Maintenance of vertical lathe
The key to the maintenance of small vertical lathe is to increase the service life of the electronic components in the CNC lathe and slow down the damage level of its parts. In this way, some common fault problems can be prevented, so as to reduce the probability of common faults of vertical cars, so as to increase the purpose of its service life.
2. Some common problems on the work of vertical lathe
In the whole process of practical operation and application of vertical lathe, there are some common problems, which are mainly as follows:
(1) to prevent dust and smudges, etc., into the motor control equipment of the vertical lathe, because, this will cause the resistance between its electrical components to be reduced, and then, there are various problems, and even destroy electronic devices.
(2) The rough surface of the product workpiece cannot be immediately installed on the surface of the operating table of the vertical lathe, but only the cushion block or the spiral top support point should be used. In addition, the alignment of the product workpiece can only be carried out when the CNC lathe operating table rotates at low speed, and cannot be carried out when it rotates at high speed.
(3) if, vertical lathe carries out unsustainable drilling production and processing, then, can be in the amount of cutting and the speed ratio of the operating table, moderately reduced, so that there is a suitable standard value.